Error Code It E
Ice Maker Motor Error — motor, gear, Hall IC, or operation circuit within icemaker kit failed to cycle; ice does not drop when IM Test S/W is pressed
Moderate
Address soon - your appliance may not work properly
Also displayed as: It E
How to Fix
- 1
Check icemaker forward status: measure voltage between CON4 Pin2 (1) and Pin10 (2). Should be 0V at rest.
- 2
Check icemaker reverse status: measure voltage between CON4 Pin2 (1) and Pin9 (3). Should be 0V at rest.
- 3
Enter icemaker test mode by pressing the ice maker test button. Observe if ice tray and motor rotate.
- 4
If motor does not rotate: check voltage during forward operation — CON4 Pin2 to Pin10 should be 11–12V.
- 5
Check voltage during reverse operation — CON4 Pin2 to Pin9 should be 11–12V.
- 6
If 11–12V is present but motor does not rotate, replace the icemaker kit.
- 7
If voltage is absent (0V) during test mode, replace the Main PCB.
Other Error Codes for LMXS28626S
Humidity Sensor Error — short or disconnection of humidity sensor
Room Temperature Sensor Error — short or disconnection of room temperature sensor
Freezer Sensor Error — short or open circuit on freezer temperature sensor
Refrigerator Sensor Error — short or open circuit on refrigerator compartment temperature sensor
Icing Sensor Error — short or open circuit on icemaker compartment sensor. If IS E displays without user input, indicates Icing Sensor fault specifically.
Defrost Sensor Error — short or open circuit on defrost/evaporator sensor
Defrost Heater Error — poor defrost due to temperature fuse disconnection, heater disconnection, drain jam, or failed heater relay; triggered after 2 consecutive incomplete defrost cycles
Freezer Fan Error — BLDC freezer fan feedback signal not received for over 65 seconds during operation